Good Morning,
I have installed touchdesigner and have searched throughout the forums and have not figured out why my 2nd monitor will not show up under window placement. I am using FTE .077 and I am running bootcamp with Windows 7 64bit. I have a NVIDIA GeForce GT 650M with 1GB for my graphics card. I am outputting through HDMI to my secondary monitor with a resolution of 1920x1080. Any help would be greatly appreciated.
Thanks
Direct your attention to the Window COMP /perform. This component is setup for your 2nd monitor out and for running in Perform Mode. First change the OP parameter so it is pointing to what you want to display on your second monitor, then set the Monitor parameter to 1 (TouchDesigner is 0-based, so first monitor is 0 and second monitor is 1). Then use the Open Parameter to open/close it while still working on the primary monitor, OR press F1 to enter Perform Mode. If you are in Perform Mode, use Esc key to exit.