CHOP/DAT reset problem

Beginners
1

Hello,
I use a oscDAT to get value from a remote but I run into a problem with all the different reset, switches that come after.

With an oscDAT, I get value to switch between a particule system(1) and a movie(2) but at the end of the movie, the particle system start automatically (when the timerChop framecount reach the length of the movie) but the value in the oscDAT is still (2) so if I use the remove to see the movie again the (2) is not working and I need to press (1) then (2) to make the full system work properly again.

Is there a way, to check if the same value in the oscDAT have been enter enter to reset a timerCHOP ?

Thank you in advance for your time and any help you could provide

2

hey, there are several possible solutions here.
It’s easiest to pick one which integrates best with your current setup if you post your .toe network.

cheers

3

Hello,
This is the part of the program that doesn’t work. Hopefully, it will help solving this issue.
Thank you in advance

ProjectDerivative.toe (13.6 KB)