FIXED: Pattern CHOP bug (when using inputs)

Bugs
1

Win11, 2022.28040

Pattern CHOP’s ‘Length’ parameter stays disabled after removing input. This only happens if I use Cut/Delete on the input CHOP, if I disconnect the wire it goes back to normal.

To reproduce:

  1. Place down a Pattern CHOP (pattern1)
  2. Place down another Pattern CHOP (pattern2)
  3. Connect pattern2 to the input of pattern1
  4. Observe pattern1’s ‘Length’ parameter - it is disabled as it should
  5. Cut or Delete pattern2
  6. pattern1’s ‘Length’ parameter stays disabled

If at 5. the connection wire gets deleted instead everything is OK.
Might be relevant for other similar CHOPs.

2

Hey @function.store

Thanks for the report and the detailed steps.

I was able to reproduce and logged an issue for a developer to look into it.

Best,
Michel

1 Like
3

This will be fixed in builds 2022.28290 and later.
Cheers

1 Like