FPS won't go further then 61 FPS

General TouchDesigner Discussion
1

Hello, I would like to run a network with 100 FPS, but it’s stuck at 61 FPS.

It’s not a heavy network, just a few tops, so I was wondering if I need to change something else too, then just the FPS in the corner? It works fine with everything less then 60 FPS.

Many thanks!!
:slight_smile: Tamiko

td question
td question887×531 34.6 KB

2

Hi @Tamikota,

the framerate in editor mode is limited by the refresh rate of your monitor.

When switching into perform mode, you can disable V-Sync on the Window COMP that is used.
You can also run your project in an Engine COMP with the Clock set to Independent.

cheers
Markus

1 Like
3

Hello Markus, thank you for the quick reply!
So can I never run a comp in 100 FPS in edit mode?

image
image1613×737 147 KB

4

Hi @Tamikota,

I should have first asked what you are trying to do as the topic quickly can become a bit a deeper discussion :slight_smile:

cheers
Markus

5

If you are on Windows, go into Nvidia Control Panel and turn Vertical Sync off (something similar on AMD). Now the editor will run whatever frame rate is possible by your monitor and project settings. Use the Window COMP’s ‘Vertical Sync’ parameter to turn V-sync on for your Perform Mode window which is recommended to avoid tearing and artifacts.

1 Like