[HELP] : cycle trough evaluate DAT table into constant

Hi everyone!

I have been trying to figure this out for quite some time but I was only able to make a constant chop cycle trough the first ten values of my table before starting over. The table consists of columns 0 - 1439 and row 0. The values range from 0-1 (ex: 0.90096).

The expression that works for the first ten values is as following:

op(‘eval4’)[int(me.time.seconds) % op(‘eval4’).numRows, 0]

Most expression which I believed to be the correct one gave an error of NoneType.

Could someone please help me figure this out.

Kind regards,

Maxim

Share your network here I can take a look.

Example.toe (9.3 KB)

This is the network! Thank you for your time.

Hi @Maximmulder,

me.time.seconds is the seconds in your timeline. By default your timeline is set to 600 frames which at 60 frames per second will equal to 10 seconds.

Instead use absTime.seconds which is the seconds passed since TouchDesigner was started.

cheers
Markus

1 Like