Would it be possible to add an arrow to find the Op that first defines a POP Attribute? Similar to the Jump to Op arrow. Trying to locate where the attribute is defined in a large network can sometimes be difficult.
Or, when an Output Attribute Scope is defined, should the label be included in the Op viewport? In a Math Combine > Combine, the Result Scope doesn’t have all of the Attributes. (I see two of three, but I’m not sure why)
I think the attribute doesn’t appear when the project is loaded. I built the network from scratch, and the attribute appears as expected. Will continue to reload the project to see if I can reproduce.
Let us know of any cases you can send us where the changed/created attribute names don’t appear in the bottom left of the POP viewer. We are trying to catch the all.
Also, we will figure out a way to inform you of where attributes going int a POP come from. Its not just where it came from but also the sequence of nodes it went through to get to a POP. This feature is on our list.
Note that WeightInverted is deleted at the end on the Output page, so would not appear listed in the POP viewer.
