Mini PC Performance

I’m trying to drive some RGB LEDs (around 4k LEDS) via DMX using this mini PC: … s-mini-pc/

I’m not sure if its purely the limitations of the computer itself but the frame-rate is excruciatingly slow (about 10 fps).

Even with a blank sketch the framerate peaks at 30 fps.

Is there perhaps a some system settings that could be causing this or is this just the wrong pc to be using?


So reading a couple things on the forum I decided to check the fps while in perform mode and it jumped up to 60 fps. What causes the big discrepancy?

possibly the many chop viewers with lot’s of samples.
Try closing the viewers (select operators, press ‘a’)