Hello everyone, I have a small issue and I hope you can help me.
The problem is that I recently bought a new camera sensor, the Orbbec Femto Mega, and when I followed the instructions in this link: (YouTube video) to install the driver, everything went fine until the CMake step in OpenCV. At that point, I couldn’t continue the installation and received an error message like the one shown in the attached image.
I hope someone can help me identify where the error is, or provide me with a guide to fully install the Femto Mega drivers so I can use the device smoothly.
Many Thanks
I just want to clarify that it’s not necessary to install any drivers or to build the SDK to use the Orbbec Femto with TouchDesigner. The SDK is already included with the TouchDesigner installer and you just need to add an Orbbec TOP or Kinect Azure TOP to your project to get the camera data.
That said, if you need to build the SDK for something else, that isn’t really in the scope of these forums but maybe someone else here is familiar with the process and can lend some advice.
