Greetings,
I am currently involved in a project that involves working with a point cloud. Specifically, I am using a txt file as the point file input. However, I have encountered an issue with regards to the camera’s view of the point cloud. Whenever I try to set geo1 (the point cloud) as the object of focus in the “Look At” setting, the point cloud disappears. I am unsure as to why this is happening and I would appreciate any assistance or advice on this matter.
Thank you, Eliot
hard to say without seeing your network or assets (can you post hem here?). But the lookat parameter gets the direction to look at from the center of the geometry you feed it, so perhaps that center is not where you think it is?
Could be be that (noise)points are recorded which are way outside of the expected geo center.
Hello,
Thank you for your prompt response. I have attached two screenshots of my network. Please let me know if there are any other assets that I should provide.
Also, is there a way to check where the center of a geometry is? I appreciate your help with this matter.
Thank you, Eliot
