(Solved) Adding wave chop to another wave chop

Beginners
1

Hey there, relatively new to TD and i have a question about the wave chop or chops in general

i want to make a stair-like pattern with a sqaure wave to skip certain values when modulating a parameter, for example: value goes from 0 to 1, then skips 1-1.5 and continues from 1.5 to 2 I want to do this with two ranges of values though. my idea was to combine the lengths of two wave chops, but i can’t figure out how to do that. in the picture i have two wave chops, the first from 1-4 in height and 1-601 in length, the second from 4-8 height and 601-1201 length. Anybody know how to combine those so that they put out a wave that goes from 1-8 H and 1-1201 L? maybe it’s really easy, but i can’t find anything on the internet and can’t figure out how to do it with math or merge chop.

Screenshot_1
Screenshot_1519×643 42.6 KB

2

Hi there,

Check out the patternCHOP. There is an option ‘ramp samples’ that increases 1 value per sample. If you make the amplitude smaller and set the ‘integer’ parameter to floor, you’ll getting a staircase. To answer your question with your approach, check out joinCHOP to ‘join’ 2 chops together.
Hope this helps.

Cheers,
tim

image
image1075×590 42.1 KB

3

omg how did i not see that. same with the join chop, literally saw it a minute after posting the question

4

thank you though