There are many non-critical reasons why a syphon/spout source could be missing. Would it make sense to change this from a red x error to a yellow warning triangle instead?
Related:
As far as I can tell, it is not possible to have a Syphon/Spout In TOP that isn’t connected to anything without it being in an error state.
This means that for a project that can sometimes be connected and disconnected to a syphon/spout source, it always shows an error when it’s disconnected.
Could we have an “Active” parameter that can be switched off so it doesn’t show an error? All of the other equivalent TOPs have something like that (Video Device In, NDI In, Video Stream In, etc).
2 Likes
+1 definitely something I would like as well.