Working with sensors with different sample rates

Let’s say you have a sensor (or series of sensors) that give you data at a few different sample rates.

25 samples per sec
15 samples per sec

What is the best practice for making sure Touchdesigner correlates the data properly? I’m guessing it’s best to set the project to the highest sample rate needed. From there, I’m using the Resample CHOP to set the new sample rates as needed for each incoming signal. Does that sound right?

I’ve come across something relating to this in my travels, but that was a year or more ago and now I can’t put my finger on it. So this may be an elementary question. I recall also that the Shuffle CHOP may have been employed.